Invacare Scorpius Livret D'instructions page 18

Scorpius
Lead-Acid Battery Charger (Optional):
Output Voltage: 100 V~240 V (Figure 24)
1. Charger output cable, 3-pin
2. AC power cord (V)
3. LED indicator (W)
- RED LIGHT ON: Pre-charging
- ORANGE LIGHT ON: Normal charging
- GREEN LIGHT ON: Fully charged.
4. It takes 7 hours for a full charge. Remove the AC plug first
after charging.
•
Each country may supply different chargers. The charging procedure may be different from
below. Chargers for lithium batteries and lead-acid batteries (optional) are different.
•
The charger LED light should indicate red when pre-charging. If not, please contact your
authorized dealer.
•
Inspect the battery charger before each use, make sure connectors are dry and clean. Do not
attempt to use an extension cord to plug in your battery charger.
•
Do not use other brands of charger to charge the scooter. Only use the charger equipped with
originally.
•
The battery charger is equipped with a cooling fan. If the fan does not appear to be working
correctly, please turn off the charger immediately as it may be overheated. Please contact your
authorized scooter dealer.
•
Do not leave the charger plugged into your scooter with charger switched off as this may
discharge your batteries. Always unplug the cables when finished charging.
•
Be aware that the battery charger case may become hot during charging. Please avoid skin
contact.
•
Keep the charger stored in a well-ventilated area. Do not drop the charger.
Charging Operation:
There are two charging ports: one is at the top of the scooter, and the other one is on the battery box.
Upper Charge Port (Figure 25)
1. Open the charge port cap.
2. Insert the charger output cable into the charge port.
3. Plug the AC cord into a standard electrical outlet on the wall.
4. Check the charger LED indicator. Make sure it is in normal charging state. During charging, LED will
indicate orange light.
5. When unplugging, please make sure to remove the AC cord from the wall first, and then the charger
output cable from the charge port.
Figure 25
Battery Box Charge Port (Figure 26)
1. Remove the battery box from the scooter and place it on flat ground.
2. Open the charge port cap and insert the charger output cable into the charge port
3. Plug the AC cord into a standard electrical outlet on the wall.
4. Check the charger LED indicator. Make sure it is in normal charging state. During charging, LED will
indicate orange light.
5. When unplugging, please make sure to remove the AC cord from the wall first, and then the charger
output cable from the charge port.
6. Put the cap back to cover the charging port before installing the battery box back in the scooter.
1654767~A_
connector (U)
Instruction Booklet
18