Starting The Comfortclean Self-Cleaning Function Manually; When To Change The Thread Catchers; Replacing The Thread Catchers; Cleaning The Roller On The Floor Brush Allteq - Miele Blizzard CX1 Electro Instructions D'utilisation

en
Starting the ComfortClean self-clean-
ing function manually (Fig. 26)
If a large amount of dust has been vac-
uumed at once, the ComfortClean self-
cleaning function should be started
manually either during a pause in vacu-
uming or straight away. This enables
the vacuum cleaner to achieve the very
best cleaning performance again
straight away.
 Press the ComfortClean button on
the activated vacuum cleaner for at
least two seconds.
The vacuum cleaner will switch itself off
for approx. 20 seconds and a cleaning
process will be carried out. You will
hear this process running.
The ComfortClean button on the vac-
uum cleaner will light up yellow.
Then the vacuum cleaner will switch it-
self back on at the last selected power
setting.
We also recommend emptying and
cleaning the fine dust container once or
twice a year (see "Fault resolution -
Cleaning the fine dust filter manually").

When to change the thread catchers?

(only possible for models with a re-
versible floorhead included as standard)
The thread catchers on the suction inlet
of the reversible floorhead can be re-
placed. Check them from time to time
and replace them if the pile has worn
down.

Replacing the thread catchers

(Fig. 27)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
18
 Insert new thread catchers.
Cleaning the roller on the floor brush
AllTeQ (Fig. 28)
(depending on model)
 Release the roller pin using a coin.
 Press out the pin and remove it.
 Remove the roller.
 Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
Miele.

Cleaning and care


Always switch off the vacuum
cleaner before cleaning it and unplug
the power chord from the wall
socket.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for use on plastic.
Follow the special cleaning instruc-
tions for the dust container and filter
frame in "Maintenance" and for the
fine dust filter, the pre-filter and the
fine dust container in "Frequently
asked questions".

Do not use abrasive cleaning
agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents!