Gaggenau BS 470 612 Instructions D'installation page 11

Undo the two screws a little, but do not completely re-
3.
move them.
Adjust the appliance door using the side screw; to do
4.
this, open the appliance door and then close it again if
necessary.
Check the alignment.
5.
Tighten both screws.
6.
5
Fit the cover cap.
7.
Slide the appliance into the cabinet opening.
8.
8.3 Combining the appliance with an oven
Fit the combi-steam oven first, then the oven.
1.
For an installation depth of 21⅝" (550 mm), position the
2.
water hoses and the connection cable in the area of the
slanted edge on the corner of the housing.
Note: The rear side of BO4.. ovens has a sloped cor-
3.
ner.
Run the inlet and outlet hose for the combi-steam oven
downwards to the connections in the rear left of the in-
stallation cabinet.
If the hoses are not kept in the rear-left corner of the in-
4.
stallation cabinet, the cabinet body must be pulled for-
wards by at least 1⅜" (35 mm), and side panels or fac-
ing must be used when installing the appliance above
an oven.
8.4 Combining the appliance with a warming
drawer - 24" (60 cm)
NOTICE:
Sharp edges on the appliance may damage the panel on
the warming drawer.
Do not damage the warming drawer panel when sliding
▶
the appliance in.
Installing the appliance en-us
11