Gaggenau BS 470 612 Instructions D'installation page 10

en-us Installing the appliance
If there is no intermediate floor above the appliance, se-
5.
cure the appliance against tipping in the cabinet. Secure
2 commercially available brackets on both sides in the
cabinet at a depth of ⅛" (450 mm), ³/₁₆" (5 mm) above
the height of the appliance.
Run the connection cable, the inlet hose and the drain
6.
hose to the connections in the rear left of the built-in
cabinet.
Push the appliance all the way into the built-in cabinet.
7.
Do not kink or trap the connection cable, the inlet
‒
hose or the drain hose.
Center the appliance.
8.
Use a spirit level to adjust the appliance so that it is per-
9.
fectly level.
Open the appliance door.
10.
Remove the red plastic transport lock from the upper
11.
door catch.
10
Secure the appliance with the enclosed screw.
12.
8.2 Appliance door adjustment
The device door is already aligned when the appliance is
delivered. Alignment is not normally required.
If required, you can adjust the alignment of the appliance
door at the hinge in order to achieve a precise gap. You
cannot adjust the height of the appliance door.
Aligning the appliance door
Pull the appliance out slightly from its cabinet opening.
1.
An oval opening is located on the top of the appliance
on the hinged side.
Remove the cover cap.
2.