Trouble Shooting - AEG A 60120 GS4 Notice D'utilisation

G G B B

Trouble shooting

During operation of the appliance some smaller but annoying trouble can often
occur, which does not require calling a technician out. In the following chart
information is given about them to avoid unnecessary charges on service.
We draw your attention that operation of appliance goes with certain sounds
(compressor- and circulating sound). This is not trouble, but means normal
operation.
We draw it to your attention again that the appliance operates
discontinuously, so the stopping of compressor does not mean being no-
current. That is why you must not touch the electrical parts of the appliance
before removing it from the mains socket.
Problem
Cooling is too weak.
Cooling is too strong
No cooling at all.
Noisy operation
Green indicator flashing
If you fail to remedy a problem, please contact the nearest authorized service unit.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm
indicator will start to flash. The product will continue to operate with the use of
a reserve system until the problem is eliminated by the local service personnel.
64
Possible cause
Thermostat is set too low.
No sufficient pre-cooling done before freezing
started.
Too large food inserted:
Too much food inserted for freezing at the same
time.
Food inserted while still hot.
Door not fully closed.
Thermostat is set too high.
Plug is not properly inserted into socket.
No current in socket.
Thermostat set to "0" position.
Product support is not correct.
Temperature sensor problem.
Solution
Set to higher position.
Provide for sufficient pre-cooling time.
Cut food into pieces.
Insert less food.
Insert food of max. room temperature.
Check if door is fully closed.
Set to lower position.
Check plug-socket connection.
Check presence of current.
Check thermostat setting.
Check stability of product support (all four feet
should stand on floor).
Call the service personnel.