Setting Cleaning Switch-Off; Maintenance And Servicing - Franke AQCT0043 Notice De Montage Et De Mise En Service

15. Setting Cleaning Switch-off

Cleaning switch-off can be set either with the remote control (not included, see
Accessories Chapter
Cleaning switch-off on the fitting
15.1 Allow your hand to approach the sensor at a distance of about 10 cm for 3 seconds.
15.2 Between the 3rd and 5th LED flash, remove your hand from the sensor detection
zone.
• LED does not flash.
15.3 After 3 to 10 seconds, allow your hand to approach the sensor again at a distance of
approx. 10 cm.
15.4 After the third LED flash, move your hand back out of the sensor detection range.
• The fitting is switched off for 3 minutes.
• The LED flashes with a 10 second cycle.
☞
When you allow your hand to approach the sensor at a distance of about 10 cm for
at least 3 seconds, the fitting is reactivated before the end of 3 minutes.

16. Maintenance and Servicing

Depending on the quality of the water, the local conditions and the rules and regula-
tions applicable on site, the fitting must be maintained and serviced at regular
intervals.
Perform maintenance on the following components:
• Aerators
• Filters (see
Properly use suitable cleaning agents that are not harmful to the fittings and rinse
with water after use. High-pressure cleaners must not be used for cleaning.
Removing the Cover Plate
To perform maintenance work it is necessary to remove the cover plate.
16.1 Remove the screws (a) from the bottom of the cover plate.
16.2 Pull the cover plate (b) down and forwards and then unhinge upwards.
16.3 Close the flow volume regulator (see
16.4 Trigger the fitting.
16) or it can be activated directly on the fitting.
Chapter 17.)
Instruction Step 10.13).
9