Setting Cleaning Switch-Off; Accessories - Franke AQCT0050 Notice De Montage Et De Mise En Service

11. Setting Cleaning Switch-off

Cleaning switch-off can be set either with the remote control (not included, see

Accessories

Chapter
Cleaning switch-off on the fitting
11.1 Allow your hand to approach the sensor at a distance of about 10 cm for 3 seconds.
11.2 Between the 3rd and 5th flash of the LED, remove your hand from the sensor
detection zone.
• LED does not flash.
11.3 After 3 to 10 seconds, allow your hand to approach the sensor again at a distance of
approx. 10 cm.
11.4 After the third LED flash, move your hand back out of the sensor detection range.
• The fitting is switched off for 3 minutes.
• The LED flashes with a 10 second cycle.
☞
When you allow your hand to approach the sensor at a distance of about 10 cm for
at least 3 seconds, the fitting is reactivated before the end of 3 minutes.
12. Accessories
Battery compartment with battery . 2000109466
6 V lithium battery,
Type CRP2. . . . . . . . . . . . . . . . 2000104846
Wall-mounted power supply . . . . . 2000109417
Extension cable for power supplies
3 m . . . . . . . . . . . . . . . . . . . . . . 2000101456
10 m . . . . . . . . . . . . . . . . . . . . . 2000101457
Power supply . . . . . . . . . . . . . . . . . 2030008704
Extension cable for power supply
3 m . . . . . . . . . . . . . . . . . . . . . . 2030010982
Remote control . . . . . . . . . . . . . . . . . . . . . . . . 2000101087
12) or it can be activated directly on the fitting.
7