Care And Maintenance - AVG PRYMO PMC30SS Manuel D'instructions

Cellier à vin - 30 bouteilles - 1 zone
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. CARE AND MAINTENANCE

DEFROST
It is unnecessary to defrost this appliance and this, even if there is ice build-up on the inner back wall because it will
defrost automatically.
 The ice build-up on the inner back wall during compressor operation will be automatically defrosted in a
compressor off cycle.
 When defrosting is in process, only the circulation fan runs.
 Defrost water will drain into the drip dish (which is found on the compressor) and the water will be evaporated
by the heat of the compressor.
CLEANING YOUR APPLIANCE
 Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
 Unplug the unit from the wall outlet.
 Remove all contents.
 Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda solution. The solution
should be made up of about 2 tablespoons of baking soda to a liter of water.
 Be sure to keep the door gasket (seal) clean at all times to keep the unit running efficiently.
 The outside of the appliance should be cleaned with mild detergent and warm water.
 Dry the interior and exterior with a soft cloth.
 Dust or any other matter that is blocking the vent may hinder the cooling efficiency of the appliance. Vacuum
the vent if necessary.
VACATION TIME
Unplug the unit from the wall outlet.
Remove all the contents.
Clean the appliance.
Leave the door slightly open to avoid possible formation of condensation, mold, or odors.
 Short vacations: Leave the appliance operating during vacations of less than three weeks.
Long vacations: If the appliance will not be used for several months, remove all contents and unplug the power
cord. Clean and dry the interior thoroughly. To prevent odor and mold, leave the door slightly open, blocking it if
necessary.
MOVING YOUR APPLIANCE
 Unplug the unit from the wall outlet.
 Remove all the contents.
 Securely tape down all loose items inside your appliance.
 Tape the doors shut.
ENERGY SAVING TIPS
The appliance should be located in the coolest area of the room, away from heat producing appliances or
heating ducts and out of the direct sunlight.
POWER FAILURE
Most power cuts recover within a few hours and should not affect the temperature of your unit if you do not open the
door frequently. If the power does not recover after a long period of time, see to it to protect the content of the unit.
29

Publicité

Chapitres

Table des Matières
loading

Table des Matières