AVG PRYMO PMC30SS Manuel D'instructions page 20

1. IMPORTANT SAFETY INSTRUCTIONS (continued)
12.Repair should only be made by authorized Service Centers only.
13. If the supply cord is damaged it must be replaced by the manufacturer, it's Service Agent or similarly qualified
persons in order to avoid a hazard.
14. In order to function at its highest potential, this wine cellar needs to be placed on flat floor and the front of the
unit completely unobstructed.
15. This unit should only be used as specified. The manufacturer will not be held responsible for any damage due to
improper use or repairs made by unqualified personnel.
16. Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption.
17. This unit is not designed for use in a garage or any other outside installation.
18. Plug the appliance into dedicated, properly installed-grounded wall outlet.
19. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an authorized Service Center.
20. This unit is not designed to be installed in an RV or used with an inverter.
DANGER
IT IS DANGEROUS FOR ANY PERSON OTHER THAN AUTHORIZED SERVICE PERSONNEL TO MAKE
REPAIRS ON THIS APPLIANCE.
DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF. IT IS DANGEROUS TO MODIFY THE
SPECIFICATIONS OF THIS PRODUCT OR CHANGE IT IN ANY MANNER. ANY DAMAGE MAY
RESULT IN A SHORT-CIRCUIT, FIRE OR ELECTRIC SHOCK.
12. DANGER - Risk of fire or explosion. Flammable refrigerant used. To be repaired only by authorized personnel.
Do not puncture refrigerant tubes.
13. DANGER - Risk of fire or explosion. Flammable refrigerant used. All safety measures must be followed.
14. DANGER - Risk of fire or explosion if refrigerant tubes are perforated. Follow the precautionary instructions.
Flammable refrigerant used.
PREPARATION

Remove the outer and inner packaging.

Before connecting the appliance to the power source, make sure it has been standing for at least 24 hours.
This will allow the refrigerant to stabilize and reduce the risk of malfunction of the cooling system resulting
from improper handling during transport.

Clean the inside surface with warm water using a soft cloth.
21