AVG PRYMO PMC30SS Manuel D'instructions page 25

3. FEATURES AND STORAGE
4. There are two bushings in the upper hinge hole of the door, one large and one small, and only one large bushing
in the lower hinge hole of the door. Remove all three and reinsert them. The one large and one small bushing
from the top are now located on the bottom of the door. Insert the large bushing from the lower hinge hole
and place it in the upper hinge hole.
5. Unscrew the lower hinge screws of the unit (located above the front right leveling leg) with a 10mm socket
wrench, and remove the hinge and rubber washer. Save the washer for the next step.
6. Install the spare lower hinge that was included in your manual bag to the cabinet above the front left leveling
leg with a socket wrench. Add the rubber washer saved from the previous step.
7. Use your thumb to press down on one of the three black capped screws on the top left corner of the cabinet.
Turn it counter clockwise to unscrew it and remove it. Repeat for the other two black capped screws and set
them safely aside.
8. Pick up the door and rotate it 180 degrees counter clockwise, so the handle is on your right side when facing
the door. Place the bottom left bushing on the newly installed bottom left hinge.
9. Align the upper hinge with the three exposed holes on the upper left cabinet and, using a Phillips head
screwdriver, use the screws from step 3 to install the hinge.
10. Align the top hinge with three holes on the left, and using a screwdriver and the left over screws from step 3,
re -install the hinge/cover.
.
26