Switching To Radio Mode; Selecting The Waveband/Memory Bank; Tuning Into A Station; Setting The Sensitivity Of Station Seek Tuning - Blaupunkt Melbourne SD27 Notice D'utilisation Et De Montage

Switching to radio mode

If you are in SD, CD changer or AUX-IN
mode,
u press the BND/TS button 4
or
u press the SRC button ? repeatedly
until the display shows "TUNER".
Selecting the waveband/memory
bank
This device can be used to receive stations
in the FM and AM frequency bands. Three
memory banks (FM1, FM2 and FMT) are
available for the FM waveband and two
memory banks (AM and AMT) for the AM
waveband.
Five stations can be stored in each memory
bank.
To switch between the memory banks FM1,
FM2 and FMT or AM and AMT,
briefl y press the BND/TS button 4.
u

Tuning into a station

There are various ways of tuning into a sta-
tion.
Automatic station seek tuning
u
Press the or
The radio tunes into the next receivable sta-
tion.
Tuning into stations manually
You can also tune into stations manually.
u or button 5.
Press the
button 5.
Setting the sensitivity of station
seek tuning
You can choose whether the radio should
only tune into stations providing good recep-
tion or whether it can also tune into those
with a weak reception.
Press the M•OK button >.
u
The display shows "MENU".
u
Press the or
until "SENS" and the currently set value
appears on the display.
"SENS HI6" means that the tuner is set to
the highest sensitivity setting. "SENS LO1"
means it is set to the lowest sensitivity set-
ting.
u Press the M•OK button > to change the
set value.
u
Set the sensitivity level that you want us-
buttons 5.
ing the
When you have fi nished making your chang-
es,
u press the M•OK button >.
To exit the menu,
u press the ESC button 6 or wait approx.
8 seconds.
Note:
You can adjust different sensitivities for
FM and AM.
Radio mode
button 5 repeatedly
13