Radio Mode; Adjusting The Tuner; Switching To Radio Mode; Convenient Rds Functions (Af, Reg) - Blaupunkt John Deere MP36 Notice D'emploi Et De Montage

Radio mode

Radio mode
This device is equipped with an RDS radio
receiver. Many of the receivable FM stations
broadcast a signal that not only carries the
programme but also additional information
such as the station name and programme
type (PTY).
The station name appears on the display as
soon as the tuner receives it.

Adjusting the tuner

To ensure proper functioning of the tuner,
the device must be set for the region in
which it is being operated. You can select
among Europe (EUROPE), America (USA),
South America (S-AMERICA), and Thailand
(THAI). The tuner is factory-set to the re-
gion in which it was sold. If you experience
problems with your radio reception, please
check this setting.
The radio functions described in these op-
erating instructions refer to the tuner set-
ting EUROPE.

Switch off the device by pressing but-
ton 1.

Hold the buttons 1 and 5 ; pressed at
the same time and switch on the device
again with the button 1.
"TUNER" is displayed.

Select your tuner region with the or
button :.
To save the setting,

switch the device off and on again or
wait approx. 8 seconds. The radio
starts playing with the last setting se-
lected (radio, CD, CD changer or AUX).


Switching to radio mode

If you are in CD, CD changer or AUX mode,
 press the BND•TS button 6
or

press the SOURCE button 4 repeat-
edly until the memory bank, e.g. "FM1",
appears on the display.

Convenient RDS functions (AF, REG)

The convenient RDS functions AF
(Alternative Frequency) and REGIONAL ex-
tend your radio's range of functions.
• AF: If the RDS function is activated, the
radio automatically tunes into the best
receivable frequency for the station
that is currently set.
• REGIONAL: At certain times, some ra-
dio stations divide their programme
into regional programmes providing
different content. You can use the REG
function to prevent the car radio from
switching to alternative frequencies
that are transmitting different pro-
gramme content.
Note:
REGIONAL must be activated/deacti-
vated separately in the menu.
Switching REGIONAL on/off

Press the MENU button 9.

Press the or button : repeated-
ly until "REG" appears on the display.
"OFF" or "ON" is displayed alongside
"REG".
To switch REGIONAL on/off,

press the or button :.

Press the MENU button 9.