Selecting The Waveband/Memory Bank; Tuning Into A Station - Blaupunkt John Deere MP36 Notice D'emploi Et De Montage

Switching the RDS function on/off
To switch the RDS functions AF and
REGIONAL on or off,

press and hold down the TRA•RDS but-
ton 7 for longer than two seconds.
The RDS functions are active when RDS
lights up in the display.
Selecting the waveband/memory
bank
This device can receive programmes broad-
cast over the FM frequency range as well as
the MW and LW (AM) wavebands. There are
three memory banks available for the FM
waveband (FM1, FM2 and FMT) and one
for each of the MW and LW wavebands.
Six stations can be stored in each memory
bank.
To switch between the FM memory banks
(FM1, FM2 and FMT) and the MW and LW
wavebands,

briefly press the BND•TS button 6.

Tuning into a station

There are various ways of tuning into a sta-
tion.
Automatic station seek tuning

Press the or button :.
The radio tunes into the next receivable sta-
tion.
Tuning into stations manually
You can also tune into stations manually.
Note:
You can only tune into stations manu-
ally if the convenient RDS function is
deactivated.
To change the set frequency in small incre-
ments,

briefly press the or button :.
To change the set frequency quickly,

press and hold down the or button
: for a longer period of time.
Browsing through broadcasting
networks (FM only)
If a radio station provides several pro-
grammes, you have the option of browsing
through its so-called "broadcasting net-
work".
Note:
The convenient RDS function must be
activated before you can use this fea-
ture.

Press the or button : to change
to the next station of the broadcasting
network.
Note:
When using this feature, you will only
be able to switch to stations that you
have received once before already. To
receive the stations, use the Scan or
Travelstore function.
Radio mode