Switching On/Off; Switching On/Off Using Button 2; Switching On/Off Using The Vehicle Ignition; Switching Off With Detachable Control Panel - Blaupunkt Melbourne SD27 Notice D'utilisation Et De Montage

Switching on/off | Timeout function | Adjusting the volume

Switching on/off

There are various ways of switching the de-
vice on/off:
Switching on/off using
button 2
u
To switch on the device, press button
2.
u
To switch off the device, press and hold
down button 2 for longer than two
seconds.
The device switches off.
Note:
To protect the vehicle battery, the de-
vice will switch off automatically after
one hour if the ignition is off.
Switching on/off using the
vehicle ignition
The device will switch on/off simultaneously
with the ignition if the device is correctly
connected to the vehicle's ignition and you
did not switch the device off by pressing
button 2.
Switching off with detachable
control panel
u
Detach the control panel.
The device switches off.

Timeout function

The device features a time-out function (time
window). If you press the M/OK > button
and select a menu item, the device switches
back after approx. 8 seconds after the last
button activation. The settings performed
are saved.
10

Adjusting the volume

You can adjust the volume in increments
from 0 (off) to 66 (maximum).
To increase the volume,
u press the + button 3.
To decrease the volume,
u press the - button 3.

Setting the power-on volume

You can set the power-on volume.
u Press the M/OK button >.
The display shows "MENU".
u
Press the or
until "ON VOLUME" appears on the dis-
play.
u button 5.
Press the
u
Adjust the power-on volume using the
buttons 5.
or
If you enable "LAST VOL", the volume which
was set the last time you switched off the
device is re-enabled.
u Press the M/OK button >.
The display shows "MENU".
u
Press the or
until "ON VOLUME" appears on the dis-
play.
u Press the button 5.
Note:
To protect your hearing, the power-on
volume is limited to the value "38". If
the volume before switching off was
higher and the "LAST VOL" setting was
selected, the device switches on again
with the value "38".
button 5 repeatedly
button 5 repeatedly