EUROM Cool-Eco 90 Wifi A++ Manual D'instructions page 49

Operation via the app
The Cool-Eco can, via Wifi, also be operated with an app. See the separate app
instruction for this.
Additional comments
 When you start the Cool-Eco and opt for a specific function or change function, the
ventilator will work but the compressor will not start immediately: the latter to
protect the internal components. The symbol that belongs to the configured
function blinks on the display, a sign of the 'waiting mode'. This can last 3 to 4
minutes.
 In case of prolonged strong cooling, ice accretion can occur on the interior of the
Cool-Eco. You notice this because the device performs less. To solve this you
switch off the device and give it time to defrost.
 When the required cooling or heating temperature has been attained, the Cool-Eco
will continue ventilating but the compressor discontinues operating.
Water outlet
During cooling and dehumidification, the device extracts water from the air. This
largely evaporates again, but possibly. excess water accumulates in the water
reservoirs. When full, the
compressor and motor
stop automatically and
the "water tank full"
(W.F) light turns on. In
that case, switch off the
air conditioning and
remove the plug from the
socket. You empty the
water reservoirs by
removing both sealing
caps from the top and
bottom water drainage
point (see pictures) and
draining the reservoirs
into a drain or collecting
them in a container or
similar. Do not forget to
replace the sealing caps
on the drain afterwards! After this you can start using the air conditioning again.
Safety
The Cool-Eco is fitted with an overheating safeguard that switches the unit off if it
overheats. If this should occur, you must remove the plug from the socket and
leave the equipment to cool for at least 30 minutes. Remove the cause of
49