Replacing The Grit Filter; Replacing The Thermostat; Replacing The Non-Return Valve - Franke AQUALINE AQLT0085 Notice De Montage Et De Mise En Service

17. Replacing the Grit Filter

Mesh washers
17.1 Remove the fitting (see
17.2 Replace the grit filters (a).
☞
Important!
Be careful to insert the grit filters the right way round.
17.3 Reassemble in the reverse order.

18. Replacing the Thermostat

Warning!
After installing the fitting or removing the thermocouple, the scald protector will need
adjusting.
Failure to observe can cause bodily harm due to scalding.
18.1 Close the flow volume regulators (see
18.2 Trigger the fitting.
18.3 Remove the cover plate (a).
18.4 Loosen the screw and the washer (b).
18.5 Remove the temperature selection knob (c) and the stop ring (d).
18.6 Remove the screw (e).
18.7 Pull out the thermostat (f).
18.8 Reassemble in the reverse order.
18.9 Adjust the scald protector (see

19. Replacing the Non-return Valve

Warning!
All non-return valves must always be replaced as a group.
Failure to observe can result in an increased bacterial load in drinking water and
cause a health risk or even risk of death.
19.1 Remove the fitting (see
19.2 Remove the mesh washer (a).
19.3 Use an Allen key to unscrew the seating (b) completely (left-hand thread).
19.4 Replace the non-return valve (c).
Caution!
Ensure that the non-return valve is installed in the right direction.
19.5 Reassemble in the reverse order.
10
Chapter 15.).
Chapter
Chapter 14.).
Chapter 15.).
10.14).