Replacing The Filters; Replace The Thermal Element; Replace The Functional Element - Franke AQLT0095 Notice De Montage Et De Mise En Service

17. Replacing the filters

17.1 Remove the cover plate (see
17.2 Unscrew the locking screws (a) on the water volume regulators.
17.3 Replace the filters (b).
☞
Important!
Note the installation position of the filters.
17.4 Reassemble in reverse order.

18. Replace the thermal element

Warning!
Set the scald protection after installing the fitting or removing the thermal element.
Failure to observe this instruction can result in injuries due to scalding.
18.1 Remove the cover plate (see
18.2 Remove the screw (b)
Caution!
Apply the pliers to the area with the largest diameter (a) behind the small sprocket
wheel.
If the sprocket wheel is damaged, the temperature selector cannot be installed.
18.3 Use pliers to remove the thermal element (c).
☞
Important!
Note the installation position of the thermal element.
18.4 Reassemble in reverse order.
18.5 Set the scald protection (see

19. Replace the functional element

19.1 Remove the cover plate (see
19.2 Remove the cover platelet.
a: Blade width 3 mm
19.3 Remove the locking ring.
19.4 Remove the compression spring and the pressure cap.
19.5 Unscrew the functional element using an Allen key.
19.6 Reassemble in reverse order.
19.7 Check the flow time and adjust where necessary (see
Chapter 16.).
Chapter 16.).
Chapter 14.).
Chapter 16.).
- 11 -
Chapter 15.).