Inner Lining; Ventilation - SCHUBERTH M1 PRO Manuel

Note:
The face shield should not be completely closed when not in use
(particularly during periods of storage), as the moisture contained on the
inside cannot escape if closed and will largely be absorbed by the anti-fog/
anti-scratch coating. This can lead to a reduction in the lifespan of the
coating.
Note:
Never attach labels, adhesive tape or stickers to the face shield or sun
visor.
Tip:
Stubborn soiling on the outside of the visor (e.g. dried-on insect residue) is
easy to remove if you cover the closed visor with a damp cloth for a few
minutes to soften the deposits. Repeat this procedure if required.
Note:
Always avoid temperatures above 40 °C and high humidity when choosing
a place to store the face shield, as these conditions can cause damage to
the face shield.

3. INNER LINING

The inner lining of the M1 PRO can be removed completely. The head and cheek
pads can be washed by hand using a mild soap solution (e.g. with highly diluted
standard mild detergent) at a maximum temperature of 30 °C. Allow the lining
to dry at room temperature and with good ventilation.

4. VENTILATION

VENTILATION COWL
When necessary, the head ventilation system's air inlet cowl can be removed to
clean the ventilation mechanism.
EN
61