GRAUPNER mx-10 Hott Manuel De Programmation page 84

Operating Notes
Self-centring screw
Brake springs
Adjuster screws
Right-hand stick unit Right-hand stick unit
Charge socket
84 Operating Notes
folding areal
Adjuster screws for stick centring force
Left-hand stick unit Left-hand stick unit
Do not touch trans- Do not touch trans-
mitter circuit board mitter circuit board
Converting the dual-axis stick units
Self-centring action
Either or both sticks can be converted from self-neutrali-
sing to non self-neutralising action: start by opening the
transmitter as described on the previous page.
If you wish to change the standard stick unit arrange-
ment, start by locating the screw on the left-hand stick
unit shown circled in white in the photo below.
Note:
The right-hand stick unit is of mirror-image construction,
i. e. the screw you require is located on the right, below
centre.
Self-centring screw
Brake springs
Adjuster screws
Turn this screw clockwise until the stick on that side
moves freely from one end-stop to the other; alterna-
tively unscrew it until the stick is fully self-centring again.