GRAUPNER mx-10 Hott Manuel De Programmation page 126

RX + VARIO
m/1s H
0
m/3s ALT
0 +500
m/10s
0 L
If a Vario module, Order No. 33601, is connected to the
receiver, then this screen provides a graphic display
of the data supplied by it. For more information on this
module please see the Appendix or refer to the product
on the Internet at www.graupner.de.
The meanings are as follows:
Value Explanation
ALT Current altitude
RXSQ Signal strength of the signal picked up
by the receiver in %
MAX The pre-set altitude limit relative to
the launch point; above this altitude
the transmitter emits audible warning
signals
MIN The pre-set altitude limit below the
launch point; below this altitude the
transmitter emits audible warning
signals
m/1s m/1 sec climb / descent
m/3s m/3 sec climb / descent
m/10s m/10 sec climb / descent
126 Program description: Telemetry menu
RX + GPS
RXSQ
N
0
MAX
W
Kmh
+500m
MIN
S
+500m
If a GPS module with integral vario, Order No. 33600,
is connected to the receiver, then this screen provides
a graphic display of the data supplied by it. For more
information on this module please see the Appendix, or
refer to the product on the Internet at www.graupner.de.
The centre of the screen shows the current positional
data and the model's speed; the display also shows the
model's current altitude in relation to the launch point, its
climb / descent rate at m/1 sec, m/3 sec and m/10 sec,
the current reception quality and the model's range from
the launch point.
The meanings are as follows:
Value Explanation
W / N / E / S West / North / East / South
Kmh Speed
RXSQ Signal strength of downlink channel
DIS Distance
ALT Current altitude relative to launch point
m/1s m/1 sec climb / descent
m/3s m/3 sec climb / descent
m/10s m/10 sec climb / descent
RXSQ 0
DIS 0m
ALT +500m
0 0m/1s
E
0m/3s
0m/10s
N 0°00.0000
E 0°00.0000