Field Limitations; Inbound Signal Features - Pentair STA-RITE CPS 10 Serie Instructions De Service

2.1 FIELD LIMITATIONS

ATTENTION
If the electrical system is equipped with a motor-generator unit and/or high power machine tools, the CPS shall be powered
via a stabilizer and filters of adequate size.
•
Environmental temperature:
+0 °C to 50 °C
•
Temperature of pumped liquid:
refer to the specific motor pump
manual
•
Level of CPS protection: IP55
•
Level of system protection:
IP55 (if installed on motors with an IP55
or superior level)
CPS complies with the Directive on Electromagnetic Compatibility EN 55014-1, EN 55014-2+A1+A2 and EN 61000-3-2, 61000-3-3.

2.2 INBOUND SIGNAL FEATURES

PRESSURE OF TRANSDUCER: (STANDARD ISSUE):
•
Pressure field: from 0 to 10 Bar
•
Outbound signal: from 0 to 5 Volt
CHAPTER 3
INSTALLATION
ATTENTION
The installation operations must be performed by expert, qualified personnel.
ATTENTION
Use specific guards and equipment as per safety standards.
ATTENTION
Fully comply with safety and accident prevention standards in force.
ATTENTION
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the
appliance.
Carefully read the use and maintenance manual for the pump.
•
Maximum operational pressure:
refer to the specific motor pump
manual
•
Voltage of inverter:
1x230 Vac ± 10 %
•
Voltage of outlet inverter:
3x230 Vac ± 10 %
•
Inbound frequency:
50/60 Hz ± 3%
•
Connection: 1⁄4 male
•
Maximum power at outlet: 1.5 kW
•
Maximum nominal outbound current:
8 Amp
•
Wave shape: sinusoidal
•
Inbound filter:
complies with EMC directive
•
Electrical connector: removable,
provided with 2 m of cable
EN
23