Charging Procedure; Autotest - bioMerieux SAMPL'AIR LITE Manuel Utilisateur

SAMPL'AIR LITE
LOW BATTERY WARNING
A 'low battery' indicator light appears on the screen (symbol
autonomy to run up to 4 cycles of 10 minutes before switching off.
A few minutes before switching off, a tone is sounded and on the message 'Low battery' is displayed.
Sampl'air Lite may be connected to the charger to prevent the cycle interruption.

Charging procedure:

Connect the battery charger to the device as shown below:
The green light indicates that the
charger is connected.
When no charger is connected, no
light switches on.
!
!
The total charging time depends on the energy level of the battery. It is
!
recommended to let the Sampl'air Lite loading at least 5 hours after a sampling
campaign.
RECYCLING OF NiMH BATTERIES:
In certain countries, it is forbidden to dispose of NiMH batteries with domestic or
office waste. Please, be sure to be informed about any local regulation.
Do not use NiHM batteries that are damaged or have leaked.

8.4 Autotest

Control and diagnosis function are present in the Sampl'air Lite.
These functions are reserved for BioMérieux S.A qualified personnel only.
52
MANUEL UTIILSATION / USER'S MANUAL
Connect the charger to the mains power supply (voltage 100 to 240 VAC+/- 10%, 50-
60 Hz, 700mA). The charger supplies a voltage of 15 V cc, 2A.
Only the charger delivered by BIOMÉRIEUX S.A must be used (FRIWO
type MPP30 FW7362).
) and indicates that your battery has enough
The red light switches on showing
that the device is charging.
The red light switches off when
the battery is loaded.
MA107501