Nolan N102 Sécurité Et Instructions D'utilisation page 14

2.3 Insert the right-hand and left-hand side flaps into the inner comfort padding by push-
ing them between the inner shell and the outer shell (Fig. 11).
2.4 Insert the left- front- and right-hand padding rear flaps in the special support in the
nape area (Fig. 10). To do this, gently work the shell edge seal and push until you hear
the locks go click.
2.5 Insert the band and the left chin strap in the special slot in the left cheek pad (Fig. 9).
2.6 Insert the rear flaps of the left cheek pad between the outer and the inner shells; push
the cheek pad towards the back of the helmet and insert the roll-neck snap button
located on the back of the cheek pad into the slot. Then press the front part of the
cheek pad in order to hook the snap button located on the back of the cheek pad. (Fig.
8) Repeat steps 2.5 and 2.6 on the right cheek pad.
WARNING!!!
- Take out the inner padding only to clean and wash it.
- Never use your helmet without having correctly and completely replaced the inner
comfort padding as well as the cheek pads.
- Do not machine wash.
- Never use any tools to carry out the above-described operations.
• NFRS – NOLAN FOG RESISTANT SYSTEM
(uses the patent licence of
1 INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Remove the protective film from the inner visor on the face in contact with the visor.
1.3 Check the inner surface of the visor is clean.
Attention: the presence of dust between the visors can produce scratches on both
surfaces.
1.4 Rest one side of the inner visor on one of the visor pins and hold it in position (Fig. 13).
1.5 Open the visor and fasten the other side of the inner visor to the second pin (Fig. 14).
1.6 Release the visor.
1.7 Remove the second protective film from the inner visor.
Attention: Check that both visors are tightly connected and do not move; if they do,
adjust the spring pins using a screwdriver to set the adherence (Fig. 15).
1.8 Fit the visor in the helmet.
ATTENTION!!!
- Make sure that the system has been assembled properly by pulling up and down the
visor.
- Scratched visors and inner visors can cause reduced visibility and must therefore be
changed.
Pinlock
® )
14