Nolan N102 Sécurité Et Instructions D'utilisation page 12

INSTRUCTIONS FOR USE
CHIN-GUARD OPENING SYSTEM
This helmet is equipped with an innovative chin guard opening system, the DUAL ACTION,
which prevents it from accidentally opening.
Note: it is not necessary to open the chin guard when putting the helmet on.
1 OPENING
1 .1 Open the visor completely.
1 .2 Push the red safety lever outwards by turning it with your thumb (Fig. 1).
Place your forefinger on top of the opening lever and push it downwards so as to lock
the chin guard (Fig. 2).
1 .3 Pull the flip-up chin guard forward, accompanying it as it rotates upwards (Fig. 3).
2 CLOSING
2 .1 Pull the chin guard downwards, accompanying it as it rotates, until you hear the clicks
of the closing mechanism.
2.2 Make sure that the chin guard is properly fastened.
IMPORTANT!!!
- Do not ride the motorcycle with the chin guard open. The chin guard MUST be
closed and fastened while riding the motorcycle.
- Do not use the helmet without the chin guard.
- Do not use the helmet in case of faulty chin guard, contact immediately an
authorized Nolan dealer.
- Do not remove nor tamper the screws that connect the chin guard to the shell.
2 CLOSING
2.1 Pull the chin guard downward and rotate until it snaps.
2.2 Make sure that the chin guard is correctly locked.
Warning: the chin-guard must be kept closed and locked wazhen the vehicle is mov-
ing.
VISOR MECHANISM
1 Disassembly
1 .1 Remove the cover plates A1 and A2 from both sides by lightly pulling the upper part.
(Fig. 4 ).
1.2 Unlock the locking bolts B by lightly pulling and rotating them from position 1 to posi-
tion 2. (Fig. 5).
1.3 Remove the bolts making sure not to lose the service springs which are inside the
bolts B.
1.4 Remove the visor.
12