Nolan N102 Sécurité Et Instructions D'utilisation page 13

2 Assembly
2.1 Put the visor in the closed position on the closed helmet.
2.2 Begin from one side and make sure that the hooking tooth of the visor automatic
recover mechanism (C) is correctly engaged in the visor reference slot (D) (Fig. 6).
2.3 Insert the locking bolt B and rotate it from position 2 to position 1 until its end is
blocked by the fixing pivot (E) (Fig. 5).
Attention: The right locking bolt (R) is different from the left one (L).
2.4 Position the plates A2 and A1 by placing the hooking splines in their seats and push
slightly until you hear the hooking click.
WARNING!!!
- For a proper functioning it is fundamental that the hooking tooth is correctly inserted
in the corresponding slot on the visor.
- Verify that the system works properly: open the visor. When raising the opening chin-
guard, the visor must close automatically.
REMOVABLE & WASHABLE COMFORT PADDING
(only for versions with removable inner padding)
1 Extraction
To remove the helmet inner padding, carry out the following operations:
1.1 Undo the chin strap (see relevant instructions), then remove one of the cheek pads
by pulling its front end towards the inside of the helmet, to snap open the button on
the pad rear end. Repeat the same operations for the other cheek pad (Fig. 8).
1.2 Remove the left cheek pad from the helmet by pulling the left chin strap out of the slot
of the cheek pad; release the roll-neck buttonhole from the snap button on the back
of the cheek pad (Fig. 9).
1.3 Release the rear fixing flap on the left-hand side from its support in the inner shell, by
gently working the shell edge seal and pulling the comfort padding at the nape height
towards the inside (Fig. 10). Then do the same for the central flap and the rear right-
hand flap.
1.4 Release the left-hand side flap from its seat between the inner shell and the outer
shell, by pulling the comfort padding towards the helmet inside (Fig. 11). Repeat the
same operation also for the right-hand side flap.
1.5 Release the front fixing flap on the left-hand side from its support in the inner shell,
by gently pulling the comfort padding towards the inside of the helmet (Fig. 12). Then
do the same for the central flap and the front right-hand flap.
1.6 Extract the comfort padding from the helmet inside.
2 Fitting
To refit the inner comfort padding, reverse the order of point 1.6 and 1.1 operations:
2.1 Correctly insert the inner padding into the helmet.
2.2 Insert the visor fixing front flaps into the shell support, by gently pushing the liner
towards the helmet outside (Fig. 12).
13