Leister GEOSTAR G5 Instructions D'utilisation page 52

Display of day's distance
The welded distance is recorded as soon as the drive is running and more than 200 N force is displayed in the
working display (34).
The day's distance can be called up as follows:
Not in welding mode
• Use the "Up" (27) and "Down" (28) arrow keys to position the cursor on the speed in the working display (34).
• Hold down the «e-Drive»
• The values of the day's distance and the total distance are now shown in the speed display.
• Briefl y pressing the «e-Drive»
In welding mode
• The speed working display (34) is blocked during welding.
• The speed setting is enabled by briefl y pressing the «e-Drive»
• Hold down the «e-Drive»
• The values of the day's distance and the total distance are now shown in the speed display.
• Briefl y pressing the «e-Drive»
speed working display (34) is blocked.
Speed blocked
52
for 5 seconds.
causes the speed to be shown again in the working display (34).
Hold pressed down for 5 sec.
Press 1 × briefly
for 5 seconds.
causes the speed to be shown again in the working display (34) and the
Speed unblocked
Display including
day's distance
.
Display including
day's distance