Leister GEOSTAR G5 Instructions D'utilisation page 41

Working display overview
Startup display
Display at the time of start-
up with software release
and device model.
Maintenance service
If the maintenance interval
for the device has been
reached, "Maintenance
Servicing" will appear after
the startup display. The dis-
play disappears automat-
ically after 10 seconds or
can be confi rmed by press-
ing «e-Drive» . You must
take the device to your ser-
vice center.
Start display
All setpoint and actual val-
ues are displayed in the
start display. The heating
is not yet switched on. All
setpoint values can be set.
Welding startup display
Display during the heating
process.
Profile selection
Select a profi le that you
have defi ned. The process
of selecting a profi le is
described in detail in the
Chapter "Select Profi le".
Setting
In the basic setting, you
can save profi les and ac-
cess the standby function
and transmission ratio via
the "Setup" menu. Select
"Advanced Mode" to ac-
cess a range of other set-
tings options.
Freely definable profiles
The process of saving
freely defi nable profi les is
described in detail in the
Chapter "Defi ning profi les".
41