Counting; Set The Average Piece Weight (Apw) - OHAUS Defender 5000 TD52P Mode D'emploi

Defender 5000 Indicators
Discrete Output 2
Discrete Output 3
Discrete Output 4
Note: The I/O's will only work when the I/O Option Board has been installed. See the Accessory list
in section 9.4 for information.
The option I/O board provides two isolated inputs and four dry-contact normally open relay outputs
which can be used for simple process weighing.
Press the button
With the button corresponding to the icon
down the list and highlight Application Mode.
Enter this sub-menu by pressing the button
corresponding to the icon
In the Application Mode menu enter the Weighing
sub-menu.
The Weighing sub-menu is now displayed.
Select the list item and press the button
corresponding to the icon
setting as desired. After completion of I/O's
setup, press the Softkey corresponding to the
icon to return to the main application
screen.

4.2 Counting

Use this application to count samples of uniform weight.
Press the button
corresponding to Counting is displayed in the
screen.
The default (or last) Average Piece Weight (APW) is
displayed.
Set the APW value according to section 4.2.1 and
then place objects on the pan to display the number
of pieces.

4.2.1 Set the Average Piece Weight (APW)

Note: It is recommended that the APW is larger than 1d. If APW is between 0.05d and 1d, a warning
message will be displayed and the information line will show 'APW is too small!'. If APW is less than
0.05d, an error message will appear and the APW value cannot be stored.
There are two methods to set the APW:
1. Entering a Known APW
Method 1
Off, Overload, Underload
Off, Overload, Underload
Off, Overload, Underload
to enter the Main Menu.
.
to change the
until the
, go
icon
EN-37