Discrete I/O; Weighing Unit; Gram (G) - OHAUS Defender 5000 TD52P Mode D'emploi

Defender 5000 Indicators
For more details, see the table below.
Application Mode
& Discrete I/O
Weighing
Counting
Check
Percent
Dynamic
Reset

3.7 Weighing Unit

Enter this menu to activate the desired units. Default settings are bold.
NOTE: Due to national laws, the indicator may not include some of the units of measure listed. If the
Security Switch is set to ON, the Units are locked at their current setting.

3.7.1 Gram (g)

Set the status.
Off = Disabled
On = Enabled
Options (bold is default)
Enable On, Off
Discrete Input1 Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Discrete Input2 Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Discrete Output1 Off, Overload, Underload, Zero
Discrete Output2 Off, Overload, Underload, Zero
Discrete Output3 Off, Overload, Underload, Zero
Discrete Output4 Off, Overload, Underload, Zero
Enable On, Off
Discrete Input1 Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Discrete Input2 Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Discrete Output1 Off, Overload, Underload, Zero
Discrete Output2 Off, Overload, Underload, Zero
Discrete Output3 Off, Overload, Underload, Zero
Discrete Output4 Off, Overload, Underload, Zero
Enable On, Off
Discrete Input1 Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Discrete Input2 Off, Zero, Tare, Clear Tare, Print, Unit, Accumulate
Off, Under, Over, Accept, Under/Over, Overload,
Discrete Output1
Underload, Zero
Off, Under, Over, Accept, Under/Over, Overload,
Discrete Output2
Underload, Zero
Off, Under, Over, Accept, Under/Over, Overload,
Discrete Output3
Underload, Zero
Off, Under, Over, Accept, Under/Over, Overload,
Discrete Output4
Underload, Zero
Enable On, Off
Enable On, Off
Discrete Input1 Off, Zero, Tare, Clear Tare, Print, Start, Reset
Discrete Input2 Off, Zero, Tare, Clear Tare, Print, Start, Reset
Discrete Output1 Off, Overload, Underload, Zero
Discrete Output2 Off, Overload, Underload, Zero
Discrete Output3 Off, Overload, Underload, Zero
Discrete Output4 Off, Overload, Underload, Zero
EN-27