Td52Xw Rear Housing Orientation; Mounting Bracket - OHAUS Defender 5000 TD52P Mode D'emploi

EN-14 Defender 5000 Indicators

2.4 TD52XW Rear Housing Orientation

The TD52XW is delivered in the wall mount orientation with the connections exiting below the display.
The rear housing may be reversed so the connections exit above the display when the TD52XW is
placed horizontally on a bench. To reverse the rear housing, remove the four Phillips head screws,
carefully rotate the housing 180°, and reinstall the screws.
Figure 2-6 Wall Mount Configuration Figure 2-7 Bench Top Configuration

2.5 Mounting Bracket

Attach the bracket to a wall or table using fasteners (not supplied) that are appropriate for the type of
mounting surface. The bracket will accommodate up to 6 mm (1/4") diameter screws. Locate the
mounting holes as shown in Figure 2-8.
Figure 2-8 Mounting Bracket Dimensions