GIERRE BAKETEK Serie Instructions Pour L'installation, L'utilisation Et La Maintenance page 55

Handle and catch
Proceed as follows:
• only at the model BAKETEK 16... Remove the two parts of the door
• undo the screws (A- Fig.19)
• replace the handle and refit all parts in reverse order;
• if necessary, turn the nut
of the handle, making sure of the correct orientation of the top of the catch
Fig. 20
C
Door seal
The seal is press-fitted, therefore it must be removed by pulling it and refitted by pressing in again
(Fig.21) .
This operation must be
In order not to damage the seal.
;
(C-Fig.20) of the catch clockwise or anti-clockwise to set the correct closing
D
Fig. 19
carried out by hand
(B-Fig. 18)
Fig. 18
Fig. 21
55
;
(D-Fig. 20) .
A
A
GB
B