Projecting - Sony VPL-CX75 Mode D'emploi

To connect to a video GBR/
Component output connector
Left side
INPUT A
AUDIO S VIDEO VIDEO
STD/DUO
2
to to
audio
audio
output output
(L) (R)
VCR
1 SMF-402 Signal Cable (not supplied)
HD D-sub 15-pin (male) ↔ 3 × phono jack
2 Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
Notes
• Set the aspect ratio using "Wide Mode" in
the INPUT SETTING menu according to the
input signal.
• When you connect the projector to a video
GBR output connector, select "Video GBR"
or when you connect the projector to a
component output connector, select
"Component" with the "Input-A Signal Sel."
setting in the SET SETTING menu.
• Use the composite sync signal when you
input the external sync signal from video
GBR/component equipment.
22
GB

Projecting

1
to video
GBR/
component
output
Projecting
2 4 6
INPUT TILT
ON/STANDBY indicator
1
Rear remote
control detector
COMMAND
OFF ON
PIC
PJ NETWORK
MUTING
AUDIO INPUT
TILT/KEYSTONE
LENS
VOLUME
APA
MENU/
TAB AIR SHOT
FREEZE
1
Plug the AC power cord into a wall
outlet, then connect all equipment.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
2
Press the I / 1 key.
The ON/STANDBY indicator lights in
green and the Advanced Intelligent
Auto-setup starts. The lens protector
opens, the powered tilt adjuster rises and
PUSH
MENU
ENTER
8
7
2
4
6,7
8
6,7,8