Sony VPL-CX75 Mode D'emploi page 23

stops at the previously adjusted position
and adjusts the focus.
Notes
• The projection size that can be adjusted
with the automatic focus adjustment is
from 40-inch up to 150-inch. However,
it may not be perfectly adjusted
depending on the brightness of the room,
the state of the screen or the use of the
Side Shot. In this case, adjust it manually
in step 8 on page 24.
• When the projector is turned on, the
Startup screen is projected (VPL-CX75
only).
For details, see the attached "Operating
Instructions for Memory Stick" stored in
the CD-ROM.
3
Turn on the equipment connected to
the projector.
4
Press the INPUT key to select the
input source.
Each time you press the key, the input
signal switches as follows:
INPUT-A t INPUT-B t VIDEO t S-VIDEO
(VPL-
CX75 only)
To input from
Computer connected to
the INPUT A connector
Air Shot/Memory Stick
(when you use the Air
Shot/Memory Stick)
(VPL-CX75 only)
Video equipment
connected to the VIDEO
input connector
Video equipment
connected to the S VIDEO
input connector
Smart APA (Auto Pixel Alignment)
adjusts the picture of the connected
equipment so that it is projected clearly.
Press INPUT to
display
INPUT-A
INPUT-B
VIDEO
S-VIDEO
Notes
• For INPUT B, input of the "Air Shot" or
"Memory Stick" can be switched by
selecting with the INPUT B selection
menu, or pressing the
AIR SHOT key on the Remote
Commander. The Air Shot Home or the
Memory Stick Home is displayed on the
screen (VPL-CX75 only).
• If "Auto Input Search" is set to "On," the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
For details, see "Auto Input Search"
on page 35.
• The Smart APA is effective for the input
signal from a computer only.
5
Switch the equipment to be connected
to output to the projector.
Depending on the type of your
computer, for example a notebook, or an
all-in-one LCD type, you may have to
switch the computer to output to the
projector by pressing certain keys
(e.g.,
/
LCD ,
VGA
changing your computer's settings.
F7
Fx
or
and
Fn
Note
The key for switching the computer to
output to the projector varies depending on
the type of a computer.
6
Adjust the upper or lower position of
the picture.
To adjust using the Remote
Commander
Press the TILT/KEYSTONE key on the
Remote Commander to display the Tilt
menu and adjust the tilt using the M/m/
</, keys.
key or the
, etc.), or by
/
23
GB
Projecting