Operation - Thermador Masterpiece Serie Manuel D'utilisation Et D'entretien

OPERATION

IMPORTANT: The most effective method of
removing vapors produced during cooking
is to:
K Switch the ventilator ON prior to
cooking or as soon as you begin
cooking.
K Switch the ventilator OFF
a few minutes after you have finished
cooking.
Display for fan setting
Light Reduce fan
speed
Fan OFF
Acoustic signal:
K When a button is pressed, this is verified
by an acoustic signal.
Switching off the acoustic signal:
K Simultaneously press buttons 0 and +
until a signal is emitted after approx.
3 seconds.
Switching on the acoustic signal:
K Repeat the process.
Switching the fan ON
K Press the + button or pull out the filter
drawer.
Setting the required fan speed:
K Press the + button.
The fan speed is increased by one step.
K Press the – button.
The fan speed is reduced by one step.
8
Delayed Shut
Off
Fan ON and
increase speed
Switching the fan OFF:
K Press the 0 button.
The displayed {
afterwards.
Or:
K Keep pressing the – button until the fan
switches off.
The displayed {
afterwards.
Intensive setting:
Maximum power is obtained at the
intensive setting.
It is only required for short intervals.
K Keep pressing the + button until a
appears in the display.
K If the intensive setting is not cancelled by
hand, the
fan will automatically switch back to step
} after 10 minutes.
Delayed Shut Off:
K Press the
button or push in the filter
!
drawer.
The fan runs for 10 minutes at setting 1.
At the same time a dot flashes in the
display.
Then the fan switches off automatically.
Lighting:
K Briefly press the
light on and off.
K The light can be switched on at any
time, even though the fan is switched off.
K Adjusting the brightness:
Hold down the a
desired brightness is obtained.
goes out shortly
goes out shortly
ç
a button to switch the
button until the