Safety Precautions; Confirming The Supplied Parts - Mitsubishi Electric PAR-SL101A-E Serie Manuel D'utilisation

1. Safety Precautions

■ Do not install in any place exposed to flammable gas leakage.
• Flammable gases accumulated around the body of PAR-SL101A-E may cause an explosion.
■ Do not use in any special environment.
• Using in any place exposed to oil (including machine oil), steam and sulfuric gas may deteriorate the performance
significantly or give damage to the component parts.
■ Do not wash with water.
• Doing so may cause an electric shock or a malfunction.
■ Do not install in any place at a temperature of more than 40 °C (104 °F) or less than 0 °C (32 °F) or exposed to
direct sunlight.
■ Do not install in any steamy place such a bathroom or kitchen.
• Avoid any place where moisture is condensed into dew. Doing so may cause an electric shock or a malfunction.
en
■ Do not install in any place where acidic or alkaline solution or special spray are often used.
• Doing so may cause an electric shock or malfunction.
■ Do not touch any circuit board with your hands or with tools. Do not allow dust to collect on the circuit board.
• Doing so may cause fire or an electric shock.
■ Do not touch any control button with your wet hands.
• Doing so may cause an electric shock or a malfunction.
■ Do not press any control button using a sharp object.
• Doing so may cause an electric shock or a malfunction.

2. Confirming the Supplied Parts

Check that the box includes the following parts in addition to this installation manual:
Wireless remote controller
Remote controller holder
LR6 AA alkaline battery
Tapping screws 3.5 × 16
Only use LR6 AA batteries. Replace low batteries with new LR6 AA batteries. Observe the polarity of the batteries as
indicated, and insert the negative end first.
2
Parts Name
CAUTION
Quantity
1
1
2
2