Mitsubishi Electric PAR-SL101A-E Serie Manuel D'utilisation page 14

4. Operation
H
en
0
1
3
2
B
C
A
D
E
12
G
1
9
6
5
7
8
4
Fig. 4-3
Fig. 4-4
Fig. 4-5
Fig. 4-6
Fig. 4-7
F
Fig. 4-8
4.6. Using the weekly timer
• This function cannot be operated depending on the model
of the indoor unit.
• The weekly timer can be set to 4 operation patterns for
each day of the week.
• The settings include the on and off times and the set
temperature.
• The operation time can be set in 10-minute increments.
<Switching to the editing mode> (Fig. 4-3, Fig. 4-4)
Press the button 1.
• C blinks.
<Selecting the setting pattern>
Press the button 2. (Fig. 4-3, Fig. 4-4)
• Each time the button 2 is pressed, the pattern
number A changes in the following order: 1 → 2 → 3 → 4.
<Selecting the day of the week>
Press the button 3. (Fig. 4-3, Fig. 4-4)
• Each time the button 3 is pressed, the day of the
week B changes in the following order: Mon → Tue →
Wed → Thu → Fri → Sat → Sun → All days.
<Selecting the operation settings>
1. Press the button 4. (Fig. 4-3, Fig. 4-5 D)
• ( ) appears.
• Each time the
switches between
2. Press the button 5. (Fig. 4-3, Fig. 4-6)
• The operation time blinks.
• Press the button 6 to set the operation time.
3. Press the button 7. (Fig. 4-3, Fig. 4-7, Fig. 4-8)
• The set temperature blinks.
• Press the button 6 to set the temperature.
• When the AUTO (dual set point) mode is enabled, press
the button 7 to switch between the upper limit
E and the lower limit F.
* When setting the off operation, the temperature cannot
be set.
<Deleting the settings> (Fig. 4-3)
Press the button 8.
• The displayed day of the week and the pattern number
settings are deleted.
<Transmitting the settings> (Fig. 4-3)
Point the transmission area of the wireless remote con-
troller towards the receiver on the indoor unit and oper-
ate the controller.
Confi rm that the indoor unit beeps 7 times.
Press the button 9.
button 4 is pressed, the setting
and .