Mitsubishi Electric PAR-SL101A-E Serie Manuel D'utilisation page 35

7. Service
Function selection procedure (Fig. 7-3, 7-4)
First, it is important to understand the procedure for the function selection. The following procedure explains how to set
"LOSSNAY connectivity" in table 1 to "Supported (indoor unit is not equipped with outdoor-air intake)" as an example.
For the actual operations, refer to the following procedure.
D
A
4
2
Fig. 7-3
Unit
Fig. 7-4
B
1
3
5
6
Mode
Setting
1. Press the button 1 to stop the air conditioner.
* If the weekly timer is enabled (
the button 2 to disable it (
2. Press the button 3 for 5 seconds.
• B comes on and the unit enters the self-check
mode.
3. Press the button 4 to set the displayed number D
to "50".
• While pointing the wireless remote controller toward
the receiver, press the
number blinks.)
4. Press the button 4 to set the unit number of the
indoor unit.
• While pointing the wireless remote controller toward
the receiver, press the
number blinks.)
* When the unit number is transmitted, the selected
indoor unit starts operating in the fan mode.
You can use this step to confirm which indoor unit
corresponds to the unit number you selected to
change the functions.
However, if you set the unit number to "00" or "AL",
all of the indoor units in the same refrigerant system
will start operating in the fan mode.
* If you transmit a unit number that cannot be
selected, the beeper sounds 3 times continuously
"beep, beep, beep (0.4 + 0.4 + 0.4 sec.)".
If this occurs, press the
set the unit number again while the unit number
display is blinking.
* If the signal was not received correctly, the beeper
will not sound or it will beep twice.
If this occurs, press the
set the unit number again while the unit number
display is blinking.
A is on), press
A is off).
en
button 5. (The unit
button 5. (The mode
button 6, and then
button 6, and then
17