Possible Causes - Eurosystems Asso 71 Notice D'instructions Et Mode D'emploi

G
B
FAULT
Engine does not start
Engine stalls
Poor cut
The drive does not function
Blade clutch does not function

POSSIBLE CAUSES

No spark
Difficulty in starting, flooded engine
Flat battery
Starter cord incorrectly connected
Grass too high or damp
Mower casing blocked
Closed throttle
Dirty air filter
Carburettor calibration incorrect
Blade badly worn
Blunt blade
Incorrect cutting height
Drive cable detached
Defective belt
Defective drive chain
Bowden pulley maladjusted
Cabling defect
Clutch damage
Charging current fuse defect
20
CORRECTION
Clean the spark plug and replace if necessary. Check the
cable
Unscrew the plug and dry it
Recharge
Check the connection
Adjust the cutting height, in high position create air flow by
reversing
Clean the casing (Important: before cleaning extract the
spark plug lead)
Open throttle by moving lever to MAX pos.
Clean air filter (see engine instructions also)
Have the calibration checked by a soecialized centre
Replace the blade
Replace or sharpen blade
Adjust the cutting height
Insert the cable
Seek assistance from Service Workshop
Seek assistance from Service Workshop
Seek assistance from Service Workshop
Seek assistance from Service Workshop
Seek assistance from Service Workshop
Fit new safety fuse