Safety Rules; Maintenance - Eurosystems Asso 71 Notice D'instructions Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

G
B
1)All persons operating the mower must be familiar with the operating instructions.
!Very important regulation: anybody under the age of 16 or under the effects of alcohol
or medicines cannot operate the machine.
2)Exhaust fumes from petrol engines: these fumes contain harmful carbon monoxide,
never operate the engine in closed environments.
3)When operating on the mower make sure that no other persons, especially children or
pets, are in the vicinity of the mower.
4)Please ensure that foreign matters (strips, twigs, iron wire, etc.) are removed from the
lawn. Splinters can be hurled outwards or the blades can get damaged.
5)No smoking in the vicinity of the mower during operation.
6)Only mow during daylight or under good lighting conditions.
7)Only mow at an angle to the slope, never up- or downwards. Special care is needed when
changing direction on slopes.
8)When driving to the area to be mowed, the mower mechanism must not be switched on.
9)Never use machine in the event of damage to the bodywork or without protective
equipment .
10)The correct position of the engine block has been specifically designed and set at the
factory and must not be altered
11)Start by pressing the drive pedal with the greatest care, following the manufacturer's
instructions. Pay attention to feet positioning at a sufficient distance from the cutting
blade.
12)Do not tilt the engine when departing and starting up.
13)Do not start the engine when the cutter mechanism is switched on. Remain sitting on the
ride-on-mower.
14)Keep your hands or feet away from the rotating blades. Stay away from the discharge
opening whilst the blade are rotating.
15)Do not manually move or lift the machine with engine running.
16)In the event of engine blockage and in all maintenance operations on the cutter
mechanism and in cases of temporary removal of the safety protections the engine
must be switched off and the cutter mechanism disengaged.
Important: remove the ignition key.
All maintenance, service and cleaning work must be carried out only after the engine has stopped and cooled off. The following operations may be carried out by the user
himself. All other maintenance, service and repair works must be carried out by an authorized dealer.
Engine check
Oil change
Filter cleaning
Spark plug checke
Air filter replacement
Air duct cleaning
Switch check
Battery and terminal cleaning
Brake check
Tyre pressure check
Blade sharpening or replacement
Loose part check
Mower cleaning

10 - SAFETY RULES

17)The engine must also be switched off:
!when you leave the machine or during its transportation
!before refuelling
18)Take the greatest care during the cutter regulation operations. Risk of injury!! Keep
fingers away from the area between cutter and bodywork. Wear gloves. Always switch
off the cutter mechanism.
19)Make sure that all nuts, bolts and screws are tight.
20)Never store the mower with petrol in the tank inside any building where petrol fumes could
possibly come into contact with fire or sparks. Danger of explosion.
21)Only empty the petrol tank in the open.
22)Before storing in a closed room, let the engine cool down.
23)In order to avoid risk of fire, the engine and exhaust must be kept free of grass, leaves
and leaking grease.
25)For safety reasons, faulty, worn or damaged parts must be replaced immediately with
original spares.
26)Replacement blades must only be installed according to the manufacturer's
instructions and in the mower they are intended for. Only in this way can the performance
and safety of your mower be ensured.
27)Take the greatest care during the blade maintenance, checking and sharpening
operations as indicated in the user's instructions.
28)Only use original spare blades, paying attention to the instructions on "blade
sharpening and replacement"
29)May we point out that, according to the law governing Product Liability, we are not
responsible for damages which are caused by our machines as a result of:
!improper repairs which were not carried out by our authorized service agents
!failure to use original spares.
The same applies for the operating accessories.

11 - MAINTENANCE

18

Publicité

Table des Matières
loading

Table des Matières