Getting Started; Preparing The Reservoir - Waterpik WP-60 Mode D'emploi

8

GETTING STARTED

Plug the cord into an electrical outlet. If the outlet is controlled by a wall
switch, be sure it is turned on.

Preparing the Reservoir

Remove reservoir from base. Fill the reservoir with lukewarm water.
Replace the reservoir over the base and press down firmly.
Inserting and Removing Tips
Pull the knob on the top of the handle toward the hose and insert tip into the
center of the knob. The colored ring will be flush with the end of the knob if
the tip is correctly locked into place. To remove tip from the handle, pull the
knob on the top of the handle toward the hose and pull tip from handle.