Getting Started; Important - Waterpik WF-13CD Mode D'emploi

6 6

GETTING STARTED

Fill
Insert
Eject
I
O
I
Pressure
I I
Setting
O
I
I I
I
2.
1.
Remove

Important!

Turn Water Flosser off and charge for 24 hours before first use. Plug the cord into any standard electrical outlet. Make sure you
push the switch into the OFF (O) position before charging. The unit will not charge if the switch is in the ON (|) position. See "Cleaning
and Troubleshooting Your Waterpik® Water Flosser" for guidance on how to look after your battery. The Waterpik® Water Flosser will
stay charged for up to 2 weeks depending on use.
Filling the Reservoir
Lift flip top on reservoir and fill the reservoir with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. The colored ring will be flush with the end of the knob if the
tip is correctly locked into place.
To remove the tip from the handle, press the tip eject button and pull tip from the handle.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by simply sliding the pressure switch on the handle.
Recommended Technique
Lean low over sink and place the tip in mouth. Aim the tip toward teeth, and turn the unit ON (|).
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefly between teeth.
Continue until you have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly close lips to avoid splashing but allow water to flow freely from
mouth into the sink. Keep unit upright during use for best results.
When Finished
Turn the unit OFF (O). Empty any liquid left in the reservoir. If desired, the reservoir may be removed from the power handle by pulling
the reservoir release latch while sliding the reservoir down towards the base of the unit.
To replace the reservoir on the power handle, simply slide it up towards the top of the unit. The reservoir will snap into place when fully engaged.