The Handheld Transmitter Lcd - Dogtra ARC 1200S Mode D'emploi

1. Attach the charging cables to both the transmitter and
receiver(s), as shown on page 47.
2. Plug the charger into a 120-volt wall outlet or if using
the accessory field charger, plug into a cigarette lighter
only for Lithium-Polymer batteries (use a 230-volt
European charger for Europe.). When properly plugged in,
all indicator lights should glow red. During the charging
process, the unit will shut off. Once the battery cable is
unplugged from the unit after a full charge,
you will need to turn the unit on again before use.
3. The Lithium-Polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process. The red light will change into a steady green light
when the battery is fully charged (when you disconnect the
charger after finishing the charge, you will need to
restart the unit).
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver/
collar.
NOTE : Only use Dogtra-approved batteries, chargers, and
accessories for your Dogtra e-collars. When a charger is not
in use, disconnect it from the power source.

8. THE HANDHELD TRANSMITTER LCD

48