Mounting The New Battery Module; Replacing The Battery Module In The Rack Model; Safety Recommendations; Battery-Module Removal - Eaton Evolution Pulsar Serie Manuel D'installation Et D'utilisation

Mounting the new battery module

Carry out the above instructions in reverse order.
To ensure safety and high performance, use only batteries supplied by EATON.
Take care to firmly press together the two parts of the connector during remounting.

5.3 Replacing the battery module in the rack model

Safety recommendations

The battery can cause electrocution and high short-circuit currents. The following safety precautions are required
before servicing the battery components:
Remove watches, rings, bracelets and all other metal objects from the hands and arms,
Use tools with an insulated handle.

Battery-module removal

A - Remove the two screws on the left-
hand side of the front panel.
B - Disconnect the battery block by
separating the two connectors (never pull
on the wires).
B
C - Remove the part.
C
5. Maintenance
34008235EN/AC - Page 17