Worx LANDROID WR140 Manuel Du Propriétaire page 37

Quick reference
The charging time is far more than
the rated charging time.
The mower does not charge.
Landroid is starting to have shorter
run-times between charges.
Landroid is not operating at the
correct time.
Landroid cannot correctly dock with
the charging base.
The green light on the charging
base turns on before charging is
complete.
Landroid wheels skid or repeatedly
slip.
Poor connection caused by debris on
the charging strip.
The charging protection program is
activated due to high temperature.
There is no power.
Something is clogging in the blade disc
creating friction and increasing power
consumption.
Landroid is shaking heavily because the
blade disc is unbalanced.
The battery may be exhausted or old.
The clock is not set to the correct time.
Programmed cutting times for Landroid
are not correct.
Environmental influences.
Poor connection caused by debris on
the charging strip.
The charging base is overheating. the
display says 'Battery temperature out of
range! please wait'.
Foreign obstacles, such as twigs and
branches may be lodged under
Landroid.
The lawn is too wet.
Clean the contact pins located on the
charging base and the charging strip on
Landroid using a cloth.
Place the charging base in a shady area
or wait until the temperature has cooled
down.
Check the power cord is connected
properly to the charger and the charger
is connected to a suitable power supply.
Make sure both the charging strips on
the mower touch the center of the
contact strips on the charging base.
Take off the blade disc and clean it.
Maybe the grass is too high and too
thick.
Check the blade disc and blades,
remove debris and foreign objects from
the blades and blade disc.
Replace the blades with a new set.
Replace battery.
Set the clock to the correct time.
Change the time settings for the mower
to start and stop.
Restart Landroid.
Clean the contact pins located on the
charging base and the charging strip on
Landroid using a cloth.
Place the charging base in a shady area
or wait until the temperature has cooled
down.
Remove foreign objects from underside
of Landroid.
Wait until lawn has dried.
EN
37