Worx LANDROID WR140 Manuel Du Propriétaire page 35

Quick reference
Can't find charge station press
START to reset.
Mower locked!
NOTES
• Before turning power on, always check Landroid is inside its working area. If not, the message "Outside working area! Press
START to reset" will be displayed. This message is also displayed when Landroid is partly but not completely inside its working
area
• If for any reason—i.e. a party, children playing...—you want to park your Landroid in the charging base: press home then OK.
Landroid will go to its base and stay there. Please note Landroid will now wait until the next scheduled mowing session. If
you want to re-start it at anytime, press start then OK to start your Landroid
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary wire so please refer to
the installation instructions and check your set up is correct with its help
• If your lawn is divided in two separated areas, connected by a corridor less than 3 ft. wide, one of which is not provided with the
charging base: when Landroid runs out of charge, take it manually to the charging base
• If Landroid runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then restart it.
If the problem cannot be solved, please contact our Customer Service for help
Boundary wire is beyond its maximum
length (1145 ft. or machine doesn't have
enough power to go back to charging
station.
With the 'Lock Function' enabled, if your
Landroid does not receive a signal from
your Wi-Fi router for 3 days, then it gets
locked as a security measure.
This could be because your router lost
its power or because you changed your
Wi-Fi router or network provider.
Take Landroid to the charging station.
Please reconnect Landroid to the Wi-Fi
networtk it has been originally paired
with.
If this is not possible, contact Cutomer
Service.
EN
35