Worx LANDROID WR140 Manuel Du Propriétaire page 31

Quick reference
Rain Delay Change
If you live in an area of high rainfall, it might be useful to adjust the rain delay setting to allow Landroid to operate when it is wet. To
do this follow these steps:
• Turn on Landroid and insert PIN code
• Press the → (D) key and press OK to select the gear icon into the 'General Settings' menu
• From the 'General Settings' menu go to 'Rain start delay' option by pressing the ↓(B) key, then press OK
• You will now see the default rain delay of 180 min. Press OK to edit this timing
• You can use the ←(C) and →(D) arrows to select the digits and ↑(A) and ↓(B) arrows to increase or decrease the rain delay
• To remove the rain delay completely, select 000 min.
• Then press back button to exit
Setting up different zones
Landroid is designed for mowing complex lawns evenly. Nevertheless, sometimes you might need to adjust the working time in
each zone. To set this feature up, first you must define these different zones of your garden (up to a maximum of 4) and then you
can adjust the working time in each one. To define each zone follow these steps:
• Start with Landroid in its charging base
• Turn on Landroid and insert PIN code
• Press the → (D) key and select clock icon and press OK to confirm
• Now you are in working time menu
• Scroll down to 'Define zones' option. Press OK
• You can select up to 4 zones
• Select the number of zones you want and press OK
• Now the display prompts you to press START to set up the zone
• As soon as you press START, the mower will start to follow the wire
• Press STOP as Landroid reaches the zone you want to mark as Zone 1
• Save your choice by selecting YES
• Press START to make Landroid reach the following zone, then press STOP when it reaches zone 2.
• Repeat the steps above if you need more zones to be defined
Customise working zones
To customise the working time in each zone:
• Turn on Landroid and insert PIN code
• Press the → (D) key
• Scroll with the → (D) key to the clock icon and press OK to confirm
• Now you are in working time menu
• Scroll down with ↓(B) key to 'Working time adjust' and press OK
• Numbered zones will appear
• Zone 1 will have a prompt to input the working area in m
• Use the ↑(A) and ↓(B) arrows to input the working area in m
• Then the cursor moves to the working percentage
• Here you can adjust the percentage
• You can then scroll to the next zone using the ←(C) and →(D) arrows to adjust the size and working time of the Zone 2
• Then press back button to exit
• Please note the sum of the percentages of all zones must equal 100%
Working time adjust
Zone 1: 001m % Work: 50%
Zone 2: 001m % Work: 50%
and the working time percentage for this zone
2
then press OK
2
EN
31