Final Steps - Worx LANDROID WR140 Manuel Du Propriétaire

Getting started
Close the loop
Once you have completed laying the wire on the perimeter of your lawn, you will arrive back to the charging base.
• Pass the wire through the guide in the base, up to the clamp (fig.10)
• Cut the exceeding wire and strip the end with a pair of scissors or wire cutters.
• Insert the stripped end into the black right clamp
10

Final steps

There are only a few more steps to go:
• Connect the charging station to the AC mains socket (fig. 11)
• If everything is fine, the LED will light green
• If there's a trouble in the loop, such as broken wire or wire ends not properly clamped, the LED will turn red. Check that everything
is fine and see the FAQ session if the problem persists
11
• Open the rear of Landroid and insert the PowerShare battery into the slot until it clicks (fig.12)
12
CLICK!
EN
17