Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Troubleshooting

PROBLEM
The device cannot be
switched on.
The CD cannot be loaded
or is ejected.
No sound
Function buttons do not
work.
The CD skips.
Device connected to the
USB slot does not work.
Radio and/or automatic
search do not work.
Station memory does not
work.
Your mobile phone is not
recognised.
UK-40
POSSIBLE CAUSE/SOLUTIONS
The ignition is not switched on.
One of the fuses is defective.
There is already a CD in the car radio.
The CD has been put in the wrong way round.
The disk is contaminated or damaged.
The temperature in the car is too high. Wait until the
environmental temperature has normalised.
Condensation! Switch the player off for a few hours
and then retry.
The volume has been set to minimum.
Cables are not properly connected.
The integrated microcomputer cannot work because
of interference. Reset (press a sharp object into the
reset opening).
The control panel is not properly fitted.
The installation angle is more than 30°.
The disk is contaminated or damaged.
Errors on CDs you have created yourself. Check the
CD in another playback device.
The USB slot is intended for devices that conform to
the USB norm. Not all devices available on the market
comply with these norms. Possibly the attached
device does not comply with these norms.
The antenna cable is not connected properly.
The station signals are too weak. Set the station
manually.
The cable for the permanent plus (yellow) is not
connected properly. For this, refer to the
"Installation", page 10 chapter.
The mobile phone is not compatible with the
Bluetooth unit.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Md 82309

Table des Matières