Advanced Settings With Push/Sel - Medion LIFE P62004 Mode D'emploi

Advanced settings with PUSH/SEL

Using the PUSH/SEL multipurpose control you can also set the initial
volume, time setting, volume of the traffic announcement, EON function,
recording format, equalizer, loudness, reception sensitivity and stereo signal.
Hold down the PUSH/SEL multipurpose control for around 2 seconds and
then press it repeatedly to open the following settings:
INVOL – set initial volume
Turn the PUSH/SEL multipurpose control to set the default volume with
which the radio should switch on.
ADJ - Set clock time
Your car radio is fitted with an RDS controlled clock. The time is set
automatically if the EON function is active and will still function even when
the radio is switched off. If you are unable to receive an RDS signal, you can
adjust the time displayed manually.
Turn the PUSH/SEL multipurpose control to the right to set the hours and
to the left to set the minutes.
TAVOL – Set volume for traffic announcements
You can set a louder volume for traffic announcements so that you can clearly
hear the announcements when the radio volume is set to low.
Turn the PUSH/SEL multipurpose control to set the volume for the traffic
announcements.
EON – Switch EON function on/off
The extended other network information
for locating a station with traffic announcements. Specifically, the device also
switches to a station with traffic announcements (or a particular PTY type) if
you are listening to a station that does not provide travel announcements.
After the announcement it switches back to the previous station.
Turn the PUSH/SEL multipurpose control to switch the EON function on
( ) or off (
EON ON
On delivery and after a reset
UK-20
).
EON OFF
EON ON
E O N
provides additional functions
is active.