Motor Limiting Table - RK Rose+Krieger PLZ-II Notice D'assemblage

7.2.5 Motor limiting table

Version
PLZ-II 30 / PLZ-i-II 30 / PLS-II 30
PLZ-II 40 / PLZ-i-II 40 / PLS-II 40
PLZ-II 50 / PLZ-i-II 50 / PLS-II 50
PLZ-II 60 / PLZ-i-II 60 / PLS-II 60
PLZ-II 80 / PLZ-i-II 80 / PLS-II 80
Transfer units
Linear units arranged in parallel must be matched to the transfer shaft to transfer torques. This
can - just as with the motor - be fixed to the steering with couplings, depending on the version.
If the designed installation length is greater than the maximum installation length or maximum
speed determined from the "estimated shaft design" formula, then a stationary bearing support
is used to absorb the corresponding loads.
Estimated shaft design:
max. installation length [mm] = (2720 - speed [min-1]) + 2 x 107.5
max. speed [min-1] = 2720 - L [mm]
The interface combinations determined by RK Rose+Krieger GmbH from coupling and transfer
unit are binding.
Steering
Max. motor weight in kg
without protection
Stationary bearing support
Centre of gravity distance
8
8
16
16
16
with protection
7. Working life
in mm
250
300
400
400
400
Steering
59